How to prolong the service life of small diameter high frequency induction coil
1. The transmission contact between the coil and the high frequency power supply should be kept in good contact to prevent heating and ignition due to large contact resistance.
2. The gap between the inner hole of the coil and the pipe must be at least 2mm to prevent the friction between the pipe and the coil in the process of high-speed operation.
3. A layer of high temperature resistant insulating material is added on the surface of the coil. Prevent coil turn to turn short circuit.
4. The welding area of the coil should be kept clean, and the cooling water inside the coil should be kept high-speed and smooth, with a certain water pressure and water flow.
5. The winding of the coil must be in place to prevent the water flow from being smooth enough to take away enough heat. Try to improve the short circuit factor of the coil, enhance the effective heating efficiency of the coil, and reduce the reactive power factor.
6. For the selection of coil copper tube materials, copper materials with high conductivity should be selected as far as possible, and alloy copper materials are not recommended.
7. Choose the coil with magnet (special design according to product requirements).
If the above seven points are considered, the service life of the coil can be effectively increased.





