+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

The welding problem when the welding seam heating area too large on small pipe with thick wall

Feb 25, 2021

In the process of high-frequency induction welding, especially in the production of thick wall and small diameter products, especially for small pipes of 1 inch and below, the wall thickness is thicker. Usually, we will encounter a wide heat affected zone at the weld, which is more than 1 / 3 of the pipe diameter or more than 1 / 2 of the pipe diameter. If the pipe diameter is smaller, even the whole pipe will be red, which will affect the final development of some products Welding performance requirements have adverse effects, and even lead to waste products.

 

Generally, we can take the following measures to deal with the problems:

 

1. To improve the welding frequency of high-frequency equipment, usually when we are clear about the requirements of the product, when we choose the equipment, we need to have requirements for the equipment in the selection of the rated frequency of the equipment.

 

2. With the application of induction coil and impedance device, the reasonable impedance device specification should be selected.

 

3. The coil with magnet design avoids the magnetic circuit and ensures the effective effect of magnetic field on the weld.

 

4. Improve the welding speed of high frequency welder, speed up the production speed and limit the heat diffusion time.

 

5. Accurate selection of coil style, adjustment of coil winding material width, scientific and reasonable selection of copper tube specification, and reduction of coil heating length.

 

6. The opening angle should be reduced as much as possible when the amount of spark is allowed.


Send Inquiry