How to improve the coupling degree between coil and steel strip mainly depends on the following three aspects:
1. Gap between coil and coil not extruded after forming
This is very easy to understand. In short, the distance between the coil and the heated workpiece is, in principle, the smaller the better. Generally, the inner diameter of the coil is recommended to be 1-2cm larger than the outer diameter of the tube.
2. Turn spacing and width of multiple coils
In principle, the smaller the turn spacing is, the better, which can reduce the magnetic circuit short circuit factor of the coil. The smaller the width of each circle, the better. However, due to the current carrying requirements, it is necessary to increase the water cooling or current carrying width according to the actual situation, so the conductive copper should be widened.
3. Improve the heating efficiency of coil magnetic circuit to the desired heating area
This is mainly to avoid the direction of the coil magnetic circuit. The main method is how to select and use the impedance or magnet scientifically and reasonably. Scientific and reasonable use can significantly improve the working efficiency of the coil.




