+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Common problems in HF Welding-3

Jan 13, 2023

Steel pipe indentation and pit

There are two types of indentation. One is linear indentation, which is caused by improper adjustment of roll position; The other is crescent-shaped indentation, which is caused by the bulge after the roll is worn. The steel pipe pit is generally caused by the bulge on the roll and the oxide skin adhered on the roll.

(1) Continuous linear indentation

Due to the poor matching of the roll positions between the rolls, it mostly occurs between the roll gaps. The indentation between the upper roll and the side roll is the most common indentation. In addition, the side roll and the bottom roll may also make indentation.

Cause: It is generally caused by improper matching of side roll and upper roll.

Adjustment method: the roll position of the upper extrusion roll can be raised or the roll position distance of both sides can be reduced.

Cause: It is generally caused by improper matching of the side roll and the lower roll,

Adjustment method: the roll position of the lower extrusion roll can be reduced or the roll position distance of both sides can be reduced.

(2)Discontinuous linear indentation

Common causes:

A. Generally, the roll bearing is damaged.

B Indentation caused by the deviation of the roller parts from the original position due to the fracture of the roller screw part on the split roller.

(3) Crescent indentation

Generally, the roller surface is worn, and there is uneven contact surface, which causes crescent indentation on the steel pipe. The crescent indentation generally occurs at the position with the largest radius of the roller, because the linear speed of the roller at this position is the largest, and the friction force is the largest. The crescent-shaped indentation can be removed by online grinding.

Send Inquiry