+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

The key element of linearity control in the quenching and heat treatment of bars and tubes1

Dec 02, 2021

In the actual on-line continuous production process of quenching heat treatment, some products have clear requirements for the linearity control of bars and tubes. Usually corresponding to the rod, if the diameter of the rod is less than 20mm, the larger the diameter of the rod, the linearity control is relatively easy, and the smaller the diameter, the corresponding linearity control needs to be paid attention to. Similarly, if the incoming material is a pipe, in addition to the diameter, the wall thickness also needs to be considered for linearity control. Generally, for wall thicknesses of 2mm and below, the corresponding linearity control needs to be paid attention to. The thicker the wall thickness, the linearity control is relatively easy.

 

So whether it is in the quenching heat treatment process of continuous production of bars or pipes, how can the straightness of the product be controlled? We need to consider and deal with the following key elements:

 

1. Incoming material requirements

 

Generally, the length of the incoming material is part of the material, usually ranging from 3 meters to 12 meters, and the linearity of the long material is generally required to be controlled within one thousandth. At the same time, it is required that there is no break point between the incoming section and the section, especially the pipe, to prevent a large amount of quenching liquid between the section and the section from entering the pipe, which will ultimately affect the straightness of the product during the quenching process. Conditionally add plugs at both ends of the pipe when incoming materials.


Send Inquiry