+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Several problems should be paid attention to in the production process.

Nov 03, 2022

Several problems should be paid attention to in the production process.


a) When installing the impedance, the front end shall not be too far beyond the center line of the extrusion roll, which is generally controlled within 3-4 mm.


b) When adjusting the impedance, do not touch the edge of the tube, otherwise the magnetic rod is easily carried away by the tube, and the distance should not be too large.


c) In the process of winding the impedance, care should be taken not to wrap it too thick, not to wrap it too thin. It should be properly determined according to the diameter, wall thickness and inner diameter of the produced steel pipe. It should ensure the water cooling gap in the middle, and there should be measures to prevent breakage.


d) During the production process, the position of the magnetic rod and whether it is taken away or broken shall be checked frequently, and the wire drawing or sundries hanging on the magnetic rod shall be removed frequently.


e) In the normal production process, short magnetic rods can be attached on both sides of the inductor, which can improve the welding efficiency (two functions: one is to strengthen the proximity effect of the tube blank edge under the inductor, reduce its eddy current loss, increase the welding current, and thus improve the welding efficiency; the other is to concentrate the inductive current on the upper half of the tube blank, which can reduce the loss of the tube back).


f) In the case of short magnetic rods, some short magnetic rods can be placed in the tube behind the magnetic rods during adjustment to make up for the insufficient length of the short magnetic rods.




g) During normal production adjustment, pay attention to the cooling of the magnetic rod, so as to reduce the service temperature of the magnetic rod and extend its service life.


In a word, magnetic rod is one of the main components of high-frequency welding (no matter contact welding or induction welding). Whether the installation position is correct or not plays a key role in improving the welding speed and quality.


Send Inquiry