+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Main influence factors of high frequency welding

Dec 10, 2021

Main influence factors of high frequency welding:

1. The frequency of high-frequency welding has a great influence on welding, because the high-frequency frequency affects the distribution of current in the steel plate. The main influence of the selected frequency on welding is the size of the heat-affected zone of the weld.

2. The meeting angle is the angle between the two sides of the steel pipe when it enters the extrusion point. Due to the proximity effect, when the high-frequency current passes through the edge of the steel plate, the edge of the steel plate will form a preheating section and a melting section (also called a lintel). When the lintel section is heated violently, the molten steel inside is rapidly vaporized and combined The blasting spurts out, forming a flash, and the size of the meeting angle has a direct effect on the molten section.

3. Welding method. There are two methods of high frequency welding: contact welding and induction welding. Contact welding uses a pair of copper electrodes in contact with the two sides of the steel pipe being welded, and the induced current has good penetration. The two effects of high-frequency current are maximized due to the direct contact between the copper electrode and the steel plate, so the welding efficiency of contact welding Higher and lower power consumption. Induction welding is to wrap one or more turns of induction coil outside the welded steel pipe. The effect of multi-turn is better than single-turn, but it is more difficult to manufacture and install multi-turn induction coil.

4. The input power control during high frequency welding is very important. If the power is too low, the billet groove heating is insufficient, and the welding temperature cannot be reached, which will cause unwelded defects such as false welding, disordering, and pinch welding; when the power is too high, the welding stability will be affected, and the billet groove surface will be heated. The temperature is much higher than the temperature required for welding, causing serious splashes, pinholes, slag inclusions and other defects. This type of defect is called an over burning defect.


Send Inquiry