+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Features of Butt Welding Machine

May 30, 2020

001

Shearing and welding machine

It can be used for steel welding pipe production, continuous stamping production and other production. It can be finished the welding work of strip material (including stainless steel,carbon steel, galvanized strip,copper,aluminum)
Features
1. Adopt oblique shear; Two down knives should be fixed on the down knife base.The base connected the frame by screws.The up knife should be installed on the moved frame.There is oil tank to move for up knife support frame.
2. Tighten; The position should be on the frame.Make two strips to keep the level and press;Tighten the position to make right and left parts;It can be controlled the air cylinder by foot switch.
3. To butt joint of right and left two pieces of strip, clamping the middle of copper electrode plates by clamping device ;The welding torch should be fixed on the moved slider,It can be drive by screw shaft.
4. The screw shaft drive by motor; The motor can be adjusted speed by the inverter output frequency, then adjust the speed of welding torch.
5. The indicator is light for right and left ,it shows pressing tightly.on the contrary,it sends the materials.
6. It can be controlled by foot switch for right and left tight;The device will be move for foot action.
7. The shear foot switch is in the middle;The up knife will cut down for pressing the switch;Then the up knife will be back for loosening the switch.
8. Adjust method:arc strike at edge 1-2.5mm;arc failure at edge 0.5-4mm.
9. Motorized button:there are front and back buttons;it can be adjusted the welding torch position by hand.Position by the indicator.
Company Overview

1111

Contact Us

name card

Send Inquiry