Solid State H.F Welding machine is composed by five parts:
1 DC Power Unit
DC Power Unit includes rectify, flight wave and control parts. 3-phase full-controllable thyristor rectifying bridge and flight wave reactor, flight wave capacitor, and filter ensure stable DC output and guarantees high quality welding.
Current meter, voltage meter and control system are equipped in the DC power unit. Thus the welder is controllable even without central control unit.
Output DC voltage 0-235V is continuously adjustable and has soft start and time constant setting.
2 Inverter Output Unit
The inverter part is mainly made up by tank circuit capacitance C and the inductive coil L. Power components all adopts MOSFET as large power component module type power unit.
LC type oscilation circuit differes to vacuum type, the tank circuit capacitance C and the inductive coil L produce resonance directly, no output transformer needed, reduce the loss greatly, and impove the efficiency. (Note: compare to vacuum tube, output efficiency can improve 25%-30%).
3 Central Control Unit
Installed with LCD, power and speed adjust module; indicate the output current and voltage of the DC power unit; armature voltage and current, excitation voltage and current of the DC speed adjust unit. The pipe line can be completely controlled by the central control unit.
4 Water-water Heat Exchange Unit
Composition:Plate heat exchanger, water tank, pump and electrical control part.
Working principle: The internal cooling is called inner water (distilled water), and the external cooling is called outer water (ordinary water). External and inner water exchange through the plate heat exchanger to reduce the temperature of the inner water. Thus, the equipment inside is cooled.
Features:
A. Seal circulation, outer water (normal) cools down the inner water (distilled water), no scaling.
B. High efficiency of heat radiation, low cost, applicable to large power H.F equipment.
C. Reservoir is used for outer water.





