+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Adjusting welding process parameters in high frequency welding Third: welding power and frequency

Jun 04, 2021

Series of factors of adjusting welding process parameters in high frequency welding


Third: welding power and frequency


In the last period, we learned the influence of the relevant knowledge of high frequency welding process on the characteristics of welding materials in the aspects of high frequency welding process elements. In this period, we learned the power and frequency of high frequency welding in product commissioning, and the status and influence on welding process.


The influence of welding power and frequency on welding process in high frequency welding is mainly analyzed as follows:


1. The influence of welding power on welding process


In the process of high frequency welding, how much welding power is suitable. In fact, under the condition of welding speed of corresponding specification products, different forming conditions of different units or different operators are not necessarily the same, because there are many subjective human factors, but no matter how the following judgment conditions can be used as the requirements of welding power:


A. Welding power must make the weld meet the melting condition required by the extrusion of the unit;


B. The cold welding cracks (insufficient welding power) are not found in the weld expansion test;


C. The weld width does not appear obvious over width and over burning (too much welding power);


D. The spark quantity at the center of welding extrusion is appropriate;


It is very important that the welding power is not suitable to directly affect the success or failure of the product debugging.


2. The influence of welding frequency on welding process


In high frequency welding, especially in induction welding, the welding frequency has the following aspects in the welding process


A. Width of heat affected zone of weld;


B. The depth of thermal penetration of the heating part of the weld;


C. The equivalent load resistance value of welding area in coil;


The influence of welding frequency parameters on the welding process quality is obvious when it is used for products with extreme wall thickness, such as thick wall pipe (wall thickness is greater than 10 mm) or thin-walled pipe (wall thickness is less than 1mm). In addition, it is very important to select frequency when welding raw materials with low permeability.


The above two aspects are the contents to be considered in the welding process parameters. In the welding process, the welding power supply can realize the independent control of power and frequency, and can realize flexible online adjustment, which increases the selection range of process window for the adjustment of welding process parameters. In the next phase, we will continue to learn the influence of welding speed on welding process. Thank you for your attention!


Send Inquiry