One of a series of factors for adjusting welding parameters in high frequency welding:extrusion roll
In the next period of time, we will learn the relevant knowledge of high-frequency welding process with everyone. There are many factors that affect the high-frequency welding process: extrusion roll, welding pipe material, welding power and frequency, welding speed, welding form (induction welding and contact welding), resistor, V angle of welding area, etc, In this issue, we learn the status and influence of extrusion roll in the welding process of product debugging.
The extrusion roll actually completes the deformation process of the whole steel strip in the whole welded pipe production line, typically from the strip forming to the pipe, such as the common steel strip into a round pipe. The roll passes arranged in the whole production line are set according to the material characteristics and final pipe shape requirements.
For high-frequency welding, in the process of debugging products, the extrusion roll on both sides of the high-frequency power output coil position is very important, which parameters of the extrusion roll can affect the adjustability of the final welding process in the process of product trial production?
1. Extrusion roll and guide before coil feeding
The position of the horizontal height of the extrusion roll directly affects the edge matching of the last steel strip, and the position of the extrusion roll guide directly affects the size of the V angle. These two points can directly affect the welding process parameters.
2. Extruding roll after winding out
In principle, the smaller the diameter of the extrusion roll is, the larger the adjustable range of the welding process is. Because the smaller the diameter of the extrusion roll is, the longer the distance between the heating area of the high frequency coil and the extrusion center is.
The above two points are the parameters that directly affect the adjustable range of the product process when debugging the product. Generally, this problem should be considered at the beginning of the project. Note that this paper only discusses the influence factors of welding process parameters adjustment in welding products, and there are many factors to consider in the actual roll design, which will not be discussed here.




