Test requirements for the thermometer
1) The welded pipeline can be produced normally
2) Avoid obstructions such as smoke, water and steam in the welding zone as much as possible
3). Compressed air for blowing the whistle for lens cleaning must ensure constant pressure and clean
4) Preheat the temperature signal transmission box (for setting parameters) for 15 minutes before use.
5). The compressed air flow rate with purge device is 0.5-1.5L/S (1-3 cfm). It is recommended to use the air of the instrument to avoid contaminants from depositing on the lens. And the air temperature cannot be lower than 10 degrees Celsius.





