First of all, we know that induction welding is not in contact with the material to be welded. After the welding area is heated to the melting state of the material by high-frequency electromagnetic induction, qualified welds are formed by extrusion to meet the welding quality requirements.
The traditional way of induction welding is to directly pass the welded pipe through the induction coil wound by copper tube or copper plate, heat the edge of the steel strip in the welding area in front of the extrusion roller through skin effect and proximity effect, and then form a weld after being extruded by the extrusion roller. So this model and welding process are almost all high-frequency induction welding methods, which are applied to various pipes. Is this the only high-frequency induction welding method? Of course not.
We know, in the high-frequency induction welding process, what is the role of the induction coil? The role of the induction coil is only to provide heat energy for the V-shaped area of a certain length in front of the extrusion roll. Heat the area to the forging temperature, as long as the V-shaped area is heated to the temperature required for forming the weld after extrusion and forging. The non perforated coil inductor can also be used to heat the skin effect and proximity effect in the V-shaped area, because the skin effect is the characteristic of induction heating, while the proximity effect is determined by the electromagnetic effect of the opposite phase current converging at the edge of the steel strip. Therefore, the non perforated coil inductor can also meet the heating requirements of high-frequency induction welding, However, because the application efficiency of non perforated coil inductor to magnetic field lines is a challenging subject, its induction efficiency is not as high as that of traditional induction welding coils, and generally needs to be configured with a magnet to improve the heating efficiency (similar to silicon steel sheet for medium frequency weld annealing inductor). Although the defects of this type of induction welding method are very obvious, and the coil efficiency is not high, the corresponding pipe product field with very thin welding thickness (less than 1mm), and the product has special material characteristics requirements, it should have its special use effect in the field of special products, and the traditional induction heating sometimes cannot meet the requirements of some products





