+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Maintenance & Testing Steps For Power Board

Jan 25, 2025

1,Test MOS (before please take off the obvious exploded ones  at first)
 

 

info-184-222info-213-160info-106-220

(1)Set the multimeter at 200K.

(2)Connect the probe respectively to G ,S ,measured resistance should be about 4.7-5K

(3)Connect the probe of multimeter respectively to G & D (Note: black one connect to D),the resistance is 78-108K.

(4)Connect the probe of multimeter respectively to D & S (Note: black one connect to D),the resistance is 70-100K.

(5)The two measured resistance is within the scope of (3) (4), meanwhile the two resistance difference is about 8K.

(6)If above requirements are not met, and short circuit occurred: you need to test G & D(Use the right gear that can test the resistance),after comparison of the resistance the lower one is the damaged one.

Send Inquiry