+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Common tools and instruments

Apr 27, 2025

Common tools and instruments

1. Common tools

In addition to electrical tools, 25W soldering iron (such as TLN-25), tin absorber, welding wire, mix files, side cutting pliers should be equipped as common tools.

2. Multimeter (such as FLUKE 17B)

Mainly used in circuit measurement. In general, semiconductor devices is measured by analog multimeter. Digital multimeter is used for signal measurement. In induction heating equipment, capacitors and inductors are of large share. Digital multimeter should have enough range to measure.

3 Clamp ammeter

Large clamp ammeter can measure more than 1000A currents, and there is more than one level of switching.

Small clamp ammeter measurement below 40A current, multi-function of AC and DC current. MOSFET tube can be measured.

4 Signal generator (for example EE1640C)

Sine wave, square wave, triangle wave signal generator can be used as load signal source when commisssiong. Its figures show should be at least 6 bits to meet 400KHZ requirements.

5 Dual trace oscilloscope (such as Tektronix TDS1012 100MHZ)

It is essential tools for commissioning and maintenance. It is mainly measures MOSFET tube's gate drain waveform, gate sourcing waveform, voltage feedback waveform, observes the drain-source voltage drop, and if there is burr on the waveform, and so on. Best select more than 20MHZ oscilloscope.

Two point in selecting the oscilloscope:

Double trace detectors should same grouding, otherwise it will cause a short circuit.

Maximum measuring voltage must comply with the oscilloscope specification requirements.

Send Inquiry