+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

Common problems in the use of high frequency welding machine

Aug 25, 2020

1、 When the induction heating device of high frequency welding machine is short of water, the protection alarm may be caused by the following reasons: 1. The water pipe is connected reversely;

 2. The power or pressure flow of the water pump is insufficient (the cooling pump of the machine tool cannot be used); the water quality is poor; 

3. The water channel is blocked. These problems are easy to solve. If the water pipe is connected reversely, it is only necessary to connect it again; when the power or pressure flow of the water pump is insufficient, the head of the water pump can be changed; when the water channel is blocked, blow it through with an air gun. 

4. When the high-frequency welding machine overheat protection alarm, it may be caused by these reasons: too little cooling water, insufficient water flow, poor water quality, possible blockage of water channel, etc. 3. When the high-frequency welding machine appears over-voltage protection alarm, the possible reasons are: the grid voltage is too high, more than 10% of the rated voltage, used in low peak power consumption, etc.

200KW

Send Inquiry