+86-18630226696

Contact Us

    China

    CHINA

    ADD: ChaoYangNan Str, 300m to BaoCang Express Way Exit, BaoDing, HeBei, China

    TEL: +86-312-2090169/2090165

    FAX: +86-312-2090165

    Email: sales02@metowd.com

    Iran

    IRAN

    ADD: No.3 - Golshid9 St. - Nakhlestan Blvd. - Shams abad industrial Zone -40km Tehran Qom Freeway - Tehran - Iran

    Postal Code: 1834175977

    Tel: 00982156231607-8

    Mob: 00989121350509

    Email: atiravesh@yahoo.com

    Anahita-GmbH

    Germany Design & Development Office

    Germany Design & Development Office

    ADD: Wellensiek 111, 33619 Bielefeld Deutschland, Germany

    Tel: 0049 521 9890 170

    Mob: 0049 163 5149 622

    Email: amir.malek@anahita-gmbh.de
    s.malek@anahita-gmbh.de

The importance of Induction coil

Jan 09, 2021

In the high frequency welding machine, the induction coil is a core component, and the distance between the induction coil and the extrusion roller axis becomes an important factor affecting the welding quality and speed. 

Generally speaking, the closer it is to the axis of the extrusion roll, the better. The key distance between the induction ring and the axis of the extrusion roll is the distance between the front end of the induction ring and the axis of the extrusion roll. In the past, the ring part and the front end of the handle part of the induction coil are in the same vertical plane. 

During assembly, the distance between the handle part of the induction coil and the rear end of the gantry should be at least 30 cm. Otherwise, the front end of the handle part of the induction coil and the rear end of the gantry will produce induction discharge, which will form a potential safety hazard. Limited by the distance between the handle of the induction ring and the gantry, the distance between the ring of the induction ring and the axis of the extrusion roll is also limited. 

The distance between the ring of the induction ring and the axis of the extrusion roll is often too far, resulting in long effective heating time and wide heat affected zone, If the heating time is shortened, the edge of the weld will not be heated enough and the forming after extrusion will not be good. Therefore, it is necessary to increase the conveying current or slow down the welding speed. Even so, the welding quality is often affected.

200kw-2

Send Inquiry